I am running Windows 10 Pro 64bit version 1607 build 14393.693 and I am at the very end of doing a clean install on my system. The last program to install was the Paragon Software Suite 15 which was running fine on my system prior to this clean install. Paragon installed properly and then it needed to restart and that is when I ran into a serious problem, Windows would not boot. I needed to insert the Windows DVD and do a repair. That allowed the system to reboot and right after that I did a system restore. Luckily I had created a restore point before I installed the Paragon Software Suite.

Any suggestions on how I can get Paragon to properly install and work on my system?
Thanks