Issue!

When doing a system backup. The error message hard disk x attributes cannot be read. So I clicked on OK then the system backup seemed to finish. But the files below all have the same date and time stamp on them. It did state the process was finished ok at the end. I wondered if this meant the backup will be ok or maybe corrupted ?. The file sizes of p63 to pbe all seem ok. I have attached a screenshot of the folder.

Backup_HDD0_20200101_0052.pfi
hdd-0.pvhd
hdd-0_e00.p63
hdd-0_e00.p64
hdd-0_e00.p65
hdd-0_e00.p66
hdd-0_e00.pbe

This archive has a PFI file (index), a pVHD file (index), all of the data files are 3.9 GB except of the last one (.066) which is smaller - as expected. After all files have been written with their own creation date the backup is finished with an index run. This writes whatsoever information to every file and thus they have all (almost) the same timestamp.

So everything looks perfect from outside.